This little beauty was made from the first wood milled by a family member's new Alaskan chainsaw mill. After this little pith slab submitted to flattening and stabilization with a little epoxy, it was cut into thirds and laminated into a small table top. From there it was finished off with four coats of General Finishes Arm-R-Seal (Semi-Gloss). The instructions advised three coats were recommended, but I was having so much fun (first time using this product) I decided to add another! Between each coat I gave the table top a sensual massage with some steel wool. With all burrs gone, that fourth coat went on and touching it after curing brought a tear to my eye.
Live Edge Cedar End Table
By Mr. Matt, Owner/Designer/Woodworker at Mr. Matt Woodworks in Murfreesboro, TN.
Project Category
Products Used
- General Finishes Arm-R-Seal (Semi-Gloss)